11
5.1 Take out the metal joint (33), soft shoulder pads (06), buckle (19) and soft crotch pad (43) from the
additional compartments of the upholstery (35) - (fig. 56).
5.2 Place the buckle (19) on the soft pad of the crotch belt (43)-(fig. 57).
5.3 Turn the buckle of the crotch belt (41)and insert in the slot (40) - (fig. 57).
5.4 Lift the fabric cover (39) and the take the buckles latches (20), then place back the fabric cover
(fig. 58).
5.5 Connect the two metal ends of the shoulder straps (20) and insert them into the buckle (19) until
you hear a “click” sound (Fig. 59).
CAUTION!
Make sure the belts are not twisted!
5.6 Adjust the headrest to the appropriate position (fig.60).
5.7 Place the soft pads on the shoulder belts (fig. 61).
5.8 Thread the shoulder belts trough the slots of headrest (38) - (fig. 61 and 62).
Turn the car seat, so the rear part is facing you.
5.9 Unzip (32) the rear seat cover (fig.63 and 64).
5.10 Attach the shoulder belts (34) on the metal joint (33) - (fig.65).
CAUTION!
Make sure the belts are not twisted!
5.11 Zip up the rear seat cover (32) - (fig.66).
6.
BUCKLE OF 5-POINT HARNESS
CAUTION!
The malfunction of the buckle can lead to serious injury of the child! :
• Do not use oil or other lubricant on any part of the buckle.
• Check and clean the buckle from traces of food or other small parts, which are the reason for
malfunction of the buckle.
Signs for malfunction of the buckle:
• Metal latches of shoulder belts release slowly, when the red button is pressed.
• The metal latches of shoulder straps do not lock into the buckle.
• There is no “click” sound at closing the metal latches in the buckle.
• The metal latches are difficult to place in the buckle, ie. you will feel resistance when placing it.
• The buckle opens only when extreme force is applied.
To clean or remove the buckle from the belt:
• Remove the buckle (fig. 67 and fig.68).
• Put the buckle in warm water with mild soap for at least 1 hour. Rinse the buckle and allow it to dry
well before placing it back on the car seat (Fig. 69).