7
GENERAL CARE AND MAINTENANCE
Cleaning the Refrigerator
Upon installation of your new appliance, it is recommended that it be cleaned thoroughly and
properly maintained thereafter.
Turn off the refrigerator and then unplug the unit from the wall outlet.
Remove all food content before washing the inside with a damp cloth soaked in lukewarm
water and baking soda solution. The solution should be about 2 tablespoons of baking soda to
a litre of water.
Be sure to keep the door gasket (seal) clean to keep the unit running efficiently as improper
cleaning can cause the seal to dislodge and tear.
The exterior of the refrigerator should be cleaned with mild detergent and warm water. (door
and side of the units only.
Dry the interior and exterior with a soft cloth.
The condenser coils should be vacuumed when they are dusty or dirty. The condenser is an
internal tube, non-serviceable.
Don’t need to remove the water tray above compressor to empty water that will be evaporated
by heat from compressor.
Vacation Time
Turn off the refrigerator first and then unplug the unit from the wall outlet.
Remove all food.
Clean the refrigerator.
Leave the lid open slightly to avoid possible formation of condensation, mold, or odors.
Use extreme caution in the case of children. The unit should not be accessible to child’s play.
Short vacations:
Leave the refrigerator operating during vacations of less than three weeks.
Long vacations:
If the appliance will not be used for several months, remove all food and
unplug the power cord. Clean and dry the interior thoroughly. To prevent odour and mold
growth, leave the door open slightly: blocking it open if necessary or have the door removed.
Repositioning and Relocating the Refrigerator
Turn off the refrigerator first and then unplug the unit from the wall outlet.
Remove all the food and drinks.
Securely tape down all loose items inside your refrigerator.
Tape the doors shut.
Be sure the refrigerator stays in the upright position during transportation.
