6
Notes: Never use sharp metal tools and it might damage the gas
pipe or inner liner and it will avoid warranty.
There is a hole with plug on the bottom back of the freezer and rubber cap
inside the freezer. When defrosting finishes, take out the plug and open the
rubber cap. The water can be collected from the drain hole.
After water come out completely, put plug and cap back to original position
and dry the freezer interior thoroughly.
Switch on the Freezer and leave it on for about three hours.
GENERAL CARE AND MAINTENANCE
Cleaning the Freezer
•
Upon installation of your new appliance, it is recommended that it be cleaned
thoroughly and properly maintained thereafter.
•
Turn off the Freezer and then unplug the unit from the wall outlet.
•
Remove all food content before washing the inside with a damp cloth soaked in
lukewarm water and dishwasher liquid.
Don’t use any chemical detergent which
might damage coating or inner liner of the freezer.
•
Be sure to keep the door gasket (seal) clean to keep the unit running efficiently as
improper cleaning can cause the seal to dislodge and tear.
•
Dry the interior and exterior with a soft cloth.
Vacation Time
•
Turn off the Freezer first and then unplug the unit from the power point.
•
Remove all food.
•
Clean the Freezer.
•
Leave the lid open slightly to avoid possible formation of condensation, mold, or odors.
•
Use extreme caution in the case of children. The unit should not be accessible to
child’s play.
•
Short vacations:
Leave the Freezer operating during vacations of less than three
