10
Temp. Setting
Before changing the setting, please make sure lock function is turned off.
Also make sure the fast freezer or fast cool mode is turned off.
Keep pressing the ‘+’ or ‘-’ to adjust the temperature to desired setting, then press the
OK key or wait for 5s to validate the temperature setting.
Temperature setting ranges cycle as follows:
In the fridge mode
：
2
℃
↔3
℃
↔4
℃
↔5
℃
↔6
℃
↔7
℃
↔8
℃；
In the freezer mode
：
-16
℃
↔
-
17
℃
↔
-18
℃
↔
-19
℃
↔
-20
℃
↔
-21
℃
↔
-22
℃
↔
-23
℃
↔
-24
℃；
Notes
The number on the display only shows the setting temperature which might vary to
the exact temperature inside the unit
Please note different sections of refrigerator compartment may be warmer or cooler
than others – typically the back wall and bottom lowest shelf will be the coolest,
the top front near the door will be the warmest. To avoid frost bite, please don’t put
raw vegetables too close to the coolest area.
Door open alarm
If any door is opened for more than 3 minutes, buzzer alarm will be continuously
beeping. It can be stopped by pressing any key button, but will be restored after 3
minutes if the door keeps opening.
The alarm will stop when the doors are closed properly.
If door open alarm is on all the time after door is reversed to another opening direction,
please check the
Door reversal instruction Page4-6
Power cut memory
In the case of power failure, the refrigerator will maintain the previous setting when the
power supply is restored.
Power-on delay
In order to protect the compressor from being damaged in the case of short-time power
failure (i.e., less than 5 minutes), the compressor will not be started immediately after it
is powered on. But it will restart after power comes back on for more than 5 minutes.
Over-temperature alarm (only after power outage)
When the refrigerator system is powered on, if the freezer sensor temperature is higher
than -10
℃
, digits of the freezer zone get flickering on the display. The freezer
temperature can be displayed when any key is pressed, and the normal display will be
restored when any key is pressed again or after 10s.
Fault alarm
In case E0, E1, E2, EH, or EC is displayed on the display panel, it indicates fault with
the refrigerator. Please contact CHIQ service centre for a service call.
