5
space of the room in which the refrigerator is installed being divided by the refrigerant charge amount of
the refrigerator shall not be less than 8 g/ M
3
.
Note: The amount of refrigerant charged for the refrigerator can be found on the nameplate.
•
Heat dissipation space
When working, the refrigerator gives off heat to surroundings. Therefore, at least
30mm
of free space
should be spared at the top side, more than 100mm on both sides, and above 50mm at the back side of the
refrigerator.
。
Dimensions in mm
W
D
H
A
B
C(°)
E
F
540
576
1800
845
1095
125±5
50
100
Note: Figure 1, Figure 2 only as a product space demand size schematic diagram.
•
Level ground
Place the refrigerator on the solid and flat ground (floor) to keep it stable, or else, it will give rise to vibration
and noise. When the refrigerator is placed on such flooring materials as carpet, straw mat, polyvinyl
chloride, the solid backing plates should be applied underneath the refrigerator, so as to prevent colour
change due to heat dissipation.
Unobstructed ventilation shall be maintained around the appliance or in an embedded structure.
Preparations for use
•
Standing time
After the refrigerator is properly installed and well cleaned, do not switch it on immediately. Make sure to
energize the refrigerator after more than 1 hour of standing, so as to ensure its normal operation.
•
Cleaning
Confirm the accessory parts inside the refrigerator and wipe the inside with a soft cloth.
•
Power-on
Insert the plug into the solid socket to start the compressor. After 1 hour, open the freezer door, if the
temperature inside the freezer compartment drops obviously, it indicates the refrigeration system is
working normally.
•
Storage of food
After the refrigerator runs for a period of time, the internal temperature of the refrigerator will be
automatically controlled according to the user’s temperature setting. After the refrigerator is fully
cooled,
put in foods, which usually need 2~3 hours to be fully cooled. In summer, when the temperature is high, it
takes more than 4 hours for the foods to be fully cooled (Try to open the refrigerator door as less as
possible before the internal temperature cools down).
If the refrigerator is installed in the moisture place, make sure to check whether the ground wire and
leakage circuit breaker are normal. If vibration noises are produced due to the refrigerator contacting the
wall or if the wall gets blackened by air convection around the compressor, move the refrigerator away from
the wall. Setting up the refrigerator may cause jamming noise or image chaos to the mobile phone, fixed-
line telephone, radio receiver, television set surrounding it, so try to keep the refrigerator as far away as
possible in such case.
Functions
Temperature setting
Temperature can be adjusted by pressing the ‘SET’ key. Every time when the “SET” key is pressed, the
current mode indicator lights off while the next mode indicator lights up, with the said mode setting
validated if no key operation within 5s (or else, the mode setting will be invalid). After the setting takes
effect, temperature will be immediately controlled as per the mode setting.
