Kinetec Kinevia™ / Kinetec Kinevia Duo™
EN
15/44
Transport
a) Before moving the device, make sure it is powered off
and that the power supply cable is disconnected.
b) Remove the connector from the power supply socket (6).
c)
Pivot the arm trainer so that the support bar is directed to
the transport castor side.
d) Tip the device over the transport castors until the Kinevia
can safely be pushed or pulled.
e) When moving it, firmly hold the device using the transport
grips with both hands.
f)
If rolling the Kinevia to the required spot is not possible
(for example due to thresholds or stairs), two people
should carry it by lifting the lower part of the frame.
The castors are not designed for transport over long
distances or on floors that are not flat.
WARNING
RISK OF INJURY DURING UNSUITABLE TRANSPORT
When being transported on stairs or uneven surfaces, the device must be
carried by at least two people.
Only use the device transport castors on hard, flat flooring.
The external power supply must be fully removed from the device for
transport.