Kinetec Kinevia™ / Kinetec Kinevia Duo™
EN
23/44
Training menu
When you select a therapy programme, a training screen is displayed:
The training screen is organised as follows:
A - Upper command panel
B - Training command panel
C - Lower command panel
Upper command panel displays and keys
①
Back key:
Used to go back to the last setting or to the previous screen.
②
Display panel:
Displays the current therapy programme, the training phase and the date and time.
The different training phases are: warm up, training, recovery.
③
Home key:
Used to go back to the home page.
Lower command panel displays and keys
④
Automatic change of rotation direction key:
This key is used to enable or disable the automatic change of pedal rotation direction.
Automated rotation
direction enabled
Automated rotation
direction disabled
Using the “settings” menu (see section 12.7 on page 36), you can adapt the time between each automatic
change of direction (the factory setting is 3 minutes).
A few seconds before the change of direction, the rotation speed drops gradually until it comes to a complete
stop. The direction changes. Then the rotation speed increases gradually until it reaches the preset value.
A
B
C
①
③
②
④
⑤
⑥
⑦
⑧
⑨