REV. 001
3/5
VITE M6x40
DADO
COPRIDADO
COPRIDADO
COPRIDADO
VITE M8x90
VITE M8x50
DADO
AUTOBLOCCANTE
DADO
AUTOBLOCCANTE
DISTANZIALI
MOLLA A GAS
Fig. 1
Fig. 2
RAMP MOUNTING DIAGRAM
HANDRAIL GAS SPRING MOUNTING DIAGRAM
COPRIDADO
COPRIDADO
DADO AUTOBLOCCANTE
RONDELLA PLASTICA
VITE TE M12x65
Fig. 3
HANDRAIL MOUNTING DIAGRAM
HANDRAIL HEIGHT ADJUSTMENT:
1. Grasp the handrails, release the position by pressing the pedal control (same effect achieved on right and left pedal)
2. Bring the handrails to the desired height and release the pedal to maintain the position.
WARNING:
During the handrail height adjustment, the springs alone will not ensure that the patient is secure on the platform.
HANDRAIL WIDTH ADJUSTMENT
1. Unscrew one of the two knobs, on each handrail, until removing the pin from the three-hole blade.
2. Loosen the other knob (on the same handrail) and pull the handgrip to remove the pin from the three-hole blade; at this stage, while carrying out
this operation with one hand, use the other hand to grab the handrail, which will now be free to move and can therefore be adjusted in width, by
inserting the pin into the desired hole.
3. Tighten this knob and then screw back and tighten the other one.
4. The handrails, when tightened to the central hole, allow using the glider, code 01380
TIGHT KNOB
LOOSE KNOB
NUT
SCREW M6x40
SCREW M8x50
NUT CAP
SELF-LOCKING NUT
SELF-LOCKING NUT
NUT CAP
GAS SPRING
SPACERS
SCREW M8x90
NUT CAP
PLASTIC WASHER
HEX. HEAD SCREW
TE M12x65
NUT CAP
SELF-LOCKING NUT
NUT CAP
www.chiroform.com
