Safety Instructions
Read the following information carefully!
The failure to follow these instructions could endanger your life, your health, the operation of
the equipment or the security of data.
- The UPS satisfies safety regulations relative to information systems and electronic machines used
in offices. If you have any questions, contact your after sales service.
- Use the right packaging for transport (protection against bumps and blows).
- The unit is equipped with a power line in compliance with safety norms and should only be connec-
ted to a grounded plug.
- The button (see chapter entitled “Button operation) does not insulate the unit from the mains.
In the event of a disconnection of mains voltage, the built-in battery will continue to supply energy to
the load.
- The power cords should be arranged in such a way as to prevent people from stepping on them or
tripping over them. When installing the unit, follow the instructions in the chapter on “Installation and
Operation”.
- Data transmission lines should not be connected or disconnected during storms.
- Prevent objects from falling into the equipment (necklaces, paper clips, etc.).
- In the event of an emergency (deterioration of the case, control or line element, penetration of liquids
or foreign bodies), disconnect the equipment, remove the connection to the mains and call your after
sales service.
CAUTION:
1. The equipment must be at least 10 cm away from the wall
2. Make sure there are no objects blocking the vent.
3. Do not place the unit near heat sources or in places exposed to direct sunlight, dust, water or
mechanical blows.
4. The equipment should only be installed in areas where the temperature is controlled and free of
conductive contaminants.
5. Use approved connection cables which support at least the voltage and intensity specified on each
model.
6. The incoming and outgoing wires must always be accessible to the user.
7. In compliance with the eletromagnetic compatibility standard (EN 50091-2) the total length of the
output cables must not exceed 10m. Likewise, the communication cables must not exceed 3 m. in
length.
8. The sum of the leakage current of the loads connected to the UPS should not exceed a total of
2.8mA.
9. Before disconnecting the UPS from the mains, disconnect the output cables connected to the load.
10. Never open the equipment. It should only be opened by qualified technical personnel. It contains
elements which have a charge even with the equipment turned off.
7
REV: 16/03/01
Operating Manual
945012.066
!
Summary of Contents for Cool Power 1200
