561105-10 en ma 2012.10
14/22
• pull
out
the
rod
(G) and spring (H) from the tap body (the pin/gasket assem-
bly (I) will slide out together with the rod);
• detach the rod (G) from the pin/gasket assembly (I);
• disassemble (by pulling) the pin (L) from the gasket (M).
7.6. Disassembling the tap
To clean the inside of the tap more thoroughly, disassemble it as follows:
• remove the tap, following the steps listed in paragraph 7.4;
• place the tap on a clean, flat surface, then loosen and remove the screw (A)
fastening the button to the machine, then slide out the pin (B) and relevant
spring (C) from the seating;
• pull the rod (D) all the way out from the knob (E) then push the lever (F)
upwards from the bottom until it comes out from the pin guide, as illustrated
in the figure;
• unscrew the knob (E) by turning it anticlockwise while holding the rod in
place;
Fig. 28
D
F
E
Fig. 29
E
Fig. 30
Fig. 27
C
B
A
G
H
I
Fig. 31
G
I
Fig. 32
M
L
