561105-10 en ma 2012.10
17/22
7.8.3 Fitting the tap
To fi t the tap correctly back in place proceed as follows:
• hold down the button, making sure that the rod is completely extracted;
• introduce the tap into the seat provided and push until the pushbutton re-
turns to its initial position.
7.9. Internal sanitization
Warning! the thermostat must be set to -OFF-.
Carry out the following steps:
• prepare the sanitising solution
(see paragraph 7.7);
• fill the bowl with the sanitising solution;
• leave the solution to act for about 30 minutes;
• empty out the sanitising solution from the bowl;
• then rinse out the bowl and inside surfaces thoroughly to eliminate all resi-
dues of sanitizing solution.
7.10. Cleaning the drip tray
The drip tray should be emptied and cleaned daily.
Note: the tray needs to be emptied out and cleaned every time
that the red float fitted to the grid rises; this is to stop liquid
from leaking out.
• lift the tray with grid and pull it outwards to remove it from its seating;
• wash the tray and grid separately with lukewarm water.;
• dry all of the components;
• reposition the grid on top of the tray;
• fit the tray back in place and press down to secure it to the machine.
7.11. Cleaning the bowl lid
• Remove the bowl lid from the machine;
• clean the surface using a damp cloth and/or a non-abrasive sponge soaked
in sanitising product.
• rinse thoroughly using clean water.
Fig. 44
1°
2°
Fig. 42
2°
1°
Fig. 43
