using the remote control
Your remote control is a universal controller for all Chord products.
This can provide a totally integrated audio solution. For the purposes of your
pre-amplifier or integrated amplifier however, we need only concern ourselves with
the buttons that are labelled in RED, as shown in the illustration on the next page.
For optimum use hold your remote control flat and point it directly at your
integrated/pre-amplifier.
selecting your input source
1. Press PRE then Bus-A.
2. Press one of: Disc 1, Disc 2, Tape 2, Video or Radio.
adjusting the volume
1. Press the volume button marked
to increase the volume.
2. Press
to decrease the volume. The volume chosen will be displayed on the
digital display with figures from 0 to 98.
choosing your output
1. Press O/P 1 if your output is connected to O/P 1 on the back of your integrated
amplifier.
2. Press O/P 2 if you are using the line output from O/P 2 on the back of your
integrated amplifier.
3. Press OP 1/2 if you are bi-amping.
Note: With the CPM2600 and CPM3300 integrated amplifiers, O/P 1 is internally
connected to the internal amplifier stage. O/P 2 is the pre-amplifier output for
connecting to an additional external amplifier.
changing the balance
1. Press the balance button marked
to move the balance towards the right.
2. Press
to move the balance to the left. The direction you are moving the
balance towards will be displayed on the digital display.
mute
1. Press Mute to mute the amplifier.
If
to unmute
y
1. Press Mute again to unmute or
2. Press the volume buttons up or down or
3. Turn the volume knob on your amplifier up or down.
the mute.
14
