Switch on the Symphonic
5.0
Connecting a pre-amplifier to Symphonic
3.0
Once all inputs are connected you should not yet initiate playback. Turn
on the Symphonic by pressing the power button on the rear panel, the
device will run its start-up sequence before it is ready to be used.
Once your vinyl player is connected to Symphonic, you then need to
connect Symphonic to your pre-amplifier. This can be done by using
either the balanced XLRs or the unbalanced RCA outputs.
Chord Electronics
Symphonic
| Quickstart Manual
The Pumphouse, Farleigh Lane, East Farleigh, Kent, ME16 9NB, United Kingdom
info@chordelectronics.co.uk
chordelectronics.co.uk
Quickstart Manual
Introduction
1.0
Welcome to the Symphonic Quickstart Guide. This shortened guide is
supplementary to the main manual which should be referred to for full
safety and operational information.
Please note, more information on any of these topics is listed within the
full manual found under the product page:
chordelectronics.co.uk/product/symphonic
Warranty
1.1
The Symphonic comes with a comprehensive 5-year warranty. To
activate this warranty, please register your device via the Chord
Electronics website:
chordelectronics.co.uk/register-product
Connecting your source to
Symphonic
2.0
In order to use the Symphonic, you must connect your source to any
input of the device. There is 2 balanced XLR inputs and 2 unbalanced
RCA inputs for connecting your turntable to Symphonic.
Input
Connect the supplied mains IEC cable to the input of Symphonic. Once
connected to the Symphonic, it may start automatically. Please make
sure none of your other devices are switched on at this point.
Connecting the power to Symphonic
4.0
Output
