Chord Electronics
ULTIMA 2 |
Manual
_
Chord Electronics
ULTIMA 2 |
Manual
_
24 // 30
25 // 30
Placement
4.1
Connecting ULTIMA 2
to ancillary equipment
4.2
4.1 Placement
4.2 Connecting ULTIMA 2 to
ancillary equipment
4.3 Audio inputs
4.1 Placement
4.2 Connecting ULTIMA 2 to
ancillary equipment
4.3 Audio inputs
4.4 Audio outputs
4.5 Power-on sequence and 12V trigger
4.6 Earthing issues in Europe
4.7 Adjusting the brightness of the LED’s
4.4 Audio outputs
4.5 Power-on sequence and 12V trigger
4.6 Earthing issues in Europe
4.7 Adjusting the brightness of the LED’s
Whilst ULTIMA 2 will operate normally
within a Chord Electronics Reference
configuration stacked via the Integra
legs or side blocks, it is recommended
that ULTIMA 2 is allowed to ‘breathe’
with 10cm of space around it to
convection-cool during operation.
When connecting the ULTIMA 2 to
equipment within the signal path,
ensure all devices are switched o
ff
. It is
recommended that once all equipment
is properly connected, that the volume
setting is operated to its lowest
setting, before slowly being raised to
a comfortable listening level. Always
observe partnering manufacturers’
guidelines.
