2. Thread a leveling foot into each corner of the pedestal and set all four to a consistent height
inside the range shown in the graphic above.
3. Install four casters into each corner of the pedestal using four M8 screws per caster.
4. Return the pedestal to its upright position.
Raising the top platform height
The adjustable height range of the top platform is 100 mm to 200 mm.
1. Remove the 16 M6 screws using a 5 mm Allen wrench (eight screws per side, four on each side
support as shown in the graphic below).
2. Raise the top platform, in increments, to the desired height and tilt angle.
3. Reinstall all 16 M6 screws.
CP4400 Series Dual LOS Pedestal Installation Instructions
Christie CP4400 Series Dual LOS Pedestal Instruction Sheet
3
020-103141-01 Rev. 1 (06-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.
