Workflow: Installing and setting up CounterAct
Identify the recommended order for installing and setting up the components of the CounterAct
system.
1. Plan the layout and power for the site (on page 18).
2. Install the CounterAct application on a tablet.
3. Log into the CounterAct application (on page 20).
When the application is first installed, it prompts you to create three accounts (installer,
administrator, and user).
4. Enter registration information for the end user (on page 20) to be used when CounterAct
devices are registered.
5. Determine if you want to pair the devices before or after installation.
•
Before installation—Pair individual devices now before installing the receiver boxes (on
page 40). Pairing one device at a time avoids confusion between devices.
•
After installation—Pair multiple devices at the same time after installing the receiver
boxes (later in step 9c). When pairing devices after installation, ensure all the MAC
addresses are recorded in advance to distinguish the devices. Use the provided sticker
with the MAC address.
6. Ensure the power is turned off at the source.
7. Install the CounterAct receiver boxes.
a) Connect to power (on page 21).
b) For pendant and ceiling surface mounting, remove the metal casing (on page 23).
Installation and setup
CounterAct Installation and Setup Guide
17
020-103456-01 Rev. 1 (09-2021)
Copyright
©
2021 Christie Digital Systems USA, Inc. All rights reserved.
Summary of Contents for 174-005106-XX
Page 1: ...Installation and Setup Guide 020 103456 01 CounterAct ...
Page 49: ......
