4
1.2.2 – Battery Specifications
Ensure that all Battery Specifications are followed when utilising the BC-RAD Select Tool System.
Battery Output
Voltage 18 VDC
Current 30 A
Charge Time
60 minutes
Charger Voltage
Input 115 VAC
Output 12 – 18 VDC
Charger Output Current
2.5 A
Table 1.2.2: Battery Specifications
1.2.3 – Environmental Specifications
CAUTION
Only operate the BC-RAD Select Tool System if the following environmental storage and
operation specifications have been met.
Temperature Ranges
̊ C
̊ F
Operating Temperature
0 – 35
32 – 95
Charging Temperature
0 – 50
32 – 122
Storage Temperature
-25 – 70
-13 – 158
Humidity
10% to 90% non-condensing
Shock
10G according to DIN IEC 68-2-6/29
Vibration
1G, 10-150Hz according to DIN IEC 68-2-6/29
Required Operating
Conditions
-
Non explosive atmosphere
-
Dry location
Table 1.2.3: Environmental Specifications
1.2.4 – Cycle of Operation
A Cycle of Operation or a Tool Cycle as used in this manual is defined as:
5 seconds forward
10 seconds rest and switch to reverse mode
5 seconds reverse mode
20 seconds rest and switch to forward mode
Note
: An actual Torque Cycle may vary from the general definition above.
2.0 – TOOL SYSTEM
The following sections give a visual and functional description of the Tool Handle, LED Display
Interface, BC-RAD Select Li-Ion Battery Pack and BC-RAD Select Battery Charger.
2.1 Tool Handle
The BC-RAD Select (Figure 2.1-1) is activated with a Trigger Switch. The Forward/Reverse Switch
controls the direction of rotation. Torque values and tool information are displayed on the 4-digit LED
display. Two buttons are used to enter the desired torque setting. The BC-RAD Select Li-Ion Battery
Pack is attached to the bottom of the Tool Handle.
Summary of Contents for BC-RAD 14XA Select
Page 17: ...15 7 0 CONTACT US ...
