Safety precautions
To prevent personal injury and to protect the device from damage, read and follow these safety
precautions.
Warning! Failure to comply with the following could result in death or serious injury.
•
SHOCK HAZARD! Disconnect the product from AC before servicing, cleaning, removing
components, or opening any enclosure.
•
EXPLOSION HAZARD! Allow sufficient time for the lamp to cool down before powering down the
product, disconnecting it from AC, and opening the lamp door.
•
All procedures must be performed by Christie qualified technicians.
•
Use protective eye wear and gloves when cleaning and servicing the product. Follow workplace
guidelines for using personal protective equipment when cleaning and servicing products.
Notice. Failure to comply with the following may result in property damage.
•
SHOCK HAZARD! All harnessing must be properly routed and secured as originally installed,
especially in high voltage areas.
Turning the projector off
When powering off in preparation for inspection or maintenance, always disconnect from AC.
1. To turn the lamps off, press and hold the Power button until you hear a beep.
It takes approximately three minutes for the lamps to cool down. When powering off the
projector, allow the projector to complete its cool down cycle. Do not immediately unplug the
projector if this can be avoided.
2. To turn off power to the projector, disconnect from AC power.
Removing the top cover
The top cover provides access to the light engine, HKBA board, and various other components.
Estimated replacement time: 1 minute
Installing the Boxer harness connector backplates
Installing the Boxer Harness Connect Backplates Instruction Sheet
2
020-102015-01 Rev. 1 (10-2015)
