Cleaning a washable filter
If the amount of dirt on the filter is minimal, use a vacuum or compressed air to remove it. If you use
compressed air, the air must move through the filter in the opposite direction of the air flow indicator
on the side of the filter.
Caution! If not avoided, the following could result in minor or moderate injury.
•
Install dry filters only. Wet or damp filters can cause an electrical short and damage the product.
1. Hold the filter on an angle under warm running water so the water flows through the filter in
the opposite direction of the air flow indicator on the side of the filter.
2. Rinse the filter thoroughly.
3. Submerge the filter for a minimum of 30 minutes in a container of warm water and two
tablespoons of mild detergent or liquid dish soap.
If the filter is extremely dirty, move the filter from side-to-side occasionally or remove the
excess dirt by brushing both sides of the filter with a soft brush.
4. Rinse the filter thoroughly by holding it on an angle under cool running water.
The air flow arrow on the side of the filter should face down.
5. If the filter still appears dirty, repeat steps 3 and 4.
6. Shake the filter over a container until most of the water is removed.
7. Place the filter on its edge on a flat, stable surface and allow it to dry thoroughly.
8. To confirm that the filter is dry, place it over a dry paper towel and shake it.
If the paper towel remains dry, the filter can be installed in the projector.
9. Record the date the filter was cleaned.
10. Replace the filter following the instructions for the specific filter.
Replacing the lens
The lens seals the projection head, preventing contaminants from entering the main electronics area.
Do not operate the projector without a lens installed. Install a lens plug when you install or transport
the projector.
1. On the touch panel Main screen, tap and hold the power button to turn off the and projector.
2. Allow the to cool for a minimum of 15 minutes.
3. Disconnect the projector from AC power or turn the circuit breaker off.
4. Install the lens cap and turn the lens clamp to the open position.
5. If necessary, remove the two cap screws securing the lens to the lens mount using a hex key.
6. Pull the lens out of the lens mount and then install a small lens cap on the rear of the lens.
7. Remove the small rear cap from the new lens.
Keep the front cap on.
8. Align the tabs on the lens plate with the lens mount.
9. Insert the lens until it connects with the magnets on the mount.
When the lens contacts the magnetic plates it is seated correctly.
10. Secure the lens clamp by rotating it clockwise.
Maintaining the projector
CP2208 User Guide
80
020-101916-03 Rev. 1 (12-20120)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.
Summary of Contents for CP2208
Page 1: ...User Guide 020 101916 03 CP2208 ...
Page 94: ......
