2-4
Pedestal and Frame Installation Manual
020-100734-02 Rev. 1 (11-2011)
Section 2: Installation and Setup
5.
Loosely fasten the 2 pedestals together using 4 M6 hex nuts, 4 M6 hex head bolts, 8 flat washers and 4 lock
washers.
NOTES:
1)
Keeping the hardware a little loose at this point will allow you to tweak the
alignment between pedestals as more are added to the platform.
2)
Do not completely tighten the hardware
on the pedestal until the first row of frames are installed. For more information, refer to
Frames onto Pedestals, on page 2-5
.
6. Slide the next pedestal into position and, using a level, adjust the height until the pedestal becomes level
with the pedestals already in the row.
7. Repeat steps 1 to 5, for each additional pedestal.
8. Verify that the entire platform structure is level and that all rear edges between pedestals are flush.
N
OTICE:
Apply downward pressure on the pedestal to ensure that the feet are flat to the floor.
9. Do not completely tighten the hardware on the pedestal until the first row of frames are installed. For more
information, refer to
2.5.2 Install Frames onto Pedestals, on page 2-5
10. Once the pedestal assembly is constructed snap the panel caps into place (see image below).
Insert panel caps here
(1 on each side)
NOTE:
Front skin not shown in image for clarity.
M6 hex head bolts
Lock washer
M6 hex nut
Flat washer
Summary of Contents for F100
