33
LWU701i/LW751i/LX801i/LWU601i/LW651i
User's Manual - Operating Guide
020-000786-0
2
LIT MAN USR D2
Status Monitor
When the projector is in a normal condition,
or displays one of the warnings of AIR FLOW,
COLD or FILTER errors, press the
FUNCTION
button on the control panel, press the
ENTER
button on the remote control for three seconds
or press one of the
MY BUTTON
buttons if
assigned as STATUS MONITOR. The backlight
of the monitor turns on.
To display the setup information including
usage time
Use the ◄/► buttons to switch display.
Usage time: The Status Monitor displays
the lamp hours (usage time of the present
lamp), the filter hours (usage time of the
air filter) and the projector usage time.
Network information: The network information is displayed over three pages.
Use the ▲/▼ buttons to switch the page.
Displayed information in each page is as below;
2nd page
: Subnet mask
(wireless and wired)
1st page
: IP address
(wireless and wired)
3rd page
: Default gateway
(wireless and wired)
(continued on next page)
2
N
1 9 2 1 6 8 0 0 1 0 7 5
W
1 9 2 1 6 8 0 0
1 9 6
I P A D D R E S S
S Y S T E M
2 2
3
8 6
h
F
I L T E R
1 2 8
3
5
h
0
L AM P
2 2 5 0
h
Displaying the log
The present setup information and the error history can be displayed on the
Status Monitor with button operation.
• While the projector is warming up, button presses are ignored.
• The Status Monitor displays nothing or no button presses for the monitor are
available while the projector is in standby mode if the STANDBY MODE item of
SETUP menu is set to POWER SAVE (
78
).
• Both of the Status Monitor and the OSD menu cannot be operated at same time.
NOTE
FUNCTION
button
ENTER
button
Usage time (example)
Network information
(example)
First display
Usage time
Network
information
Lamp hours
Filter hours
Projector
usage time
Wired
Wireless
Summary of Contents for LW651i
Page 131: ......
