11. Remove the shutter.
The wire for the shutter is thin and fragile. It can easily get caught and pinched between the
upper and lower engine housing during disassembly and assembly. Make sure the wire is not
pinched during reassembly.
12. To re-install, follow these steps in reverse order.
Removing the integrator assembly
The assembly connects to the front optical housing which is a hard casting. The integrator is sealed
and can be adjusted by two adjustment screws, one for the horizontal and one for the vertical. Light
enters from the side of the integrator and is directed at the angle of incidence for total internal
reflection to occur.
Estimated replacement time: 53 minutes.
Caution! If not avoided, the following could result in minor or moderate injury.
•
Always wear clean, lint-free gloves when handling the product.
Each lamp has one integrator. One integrator is shorter because the light travels a shorter distance.
1. Remove the top cover (on page 45).
2. Remove the card cage lid (on page 59).
3. Remove the bridge (on page 60).
4. Remove the optical assembly (on page 78).
5. Remove the four screws securing the rear optical housing to the front optical housing.
6. Remove the rear optical housing and integrator from the front optical housing.
7. Remove the four screws securing the integrator assembly to the rear optical housing.
8. Disconnect the integrator assembly using one guide pin.
9. To re-install, follow these steps in reverse order.
Removing the fold mirror
The fold mirror assembly is part of the optical assembly. It attaches to the rear optical housing where
there are three adjustment screws and two small set screws. The bottom screw is not as accessible; it
is located beneath the light sensor module (LSM).
Estimated replacement time: 60 minutes.
Optics
M Series Service Guide
75
020-100551-11 Rev. 1 (01-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.
Summary of Contents for M Series
Page 1: ...Service Guide 020 100551 11 M Series ...
Page 95: ......
