Installation & Setup
2-2
Roadster & Mirage S+/HD User Manual
020-100002-04 Rev. 1 (12-2008)
WARNING
Line cord replacement must be performed by qualified service
personnel in accordance with specific national electrical safety
regulations. For details, refer to the Service Manual and contact
your dealer.
•
The
Roadster
S+
12K/HD12K and the Mirage HD12
require 200-240 VAC, 50-
60 Hz, 12 amps @ 200 VAC.
•
The
Roadster
S+
16K
and the
Mirage
S+
14K
require 200-240 VAC, 50-60 Hz,
16 amps @ 200 VAC.
•
The
Roadster
S+
20K/HD18K/Mirage HD18
require 200-240 VAC, 50-60 Hz,
24 amps @ 200 VAC.
WARNING
Do not attempt operation if the AC supply and cord are not
within the specified voltage and power range. Refer to
Section 6
.
Turn On the Projector and Lamp
1.
On the projector, turn the power
breaker/switch on. The LCD Status
Display Window displays the
initializing window for 15 seconds,
and then indicates
POWER OFF
(Figure 2.1).
2.
Using the keypad, do one of the
following:
• Press and hold
briefly to
toggle the lamp on.
• Press and release
followed
immediately by
.
• Press
to toggle from the
off state.
The LCD Status Display Window
will display
Powering Up
and
then,
Power On
(Figure 2.1) while
the two-digit Status/Error Code
Window will display
ON
.
Select a Source
Using either keypad, press
Input 1
,
Input 2
,
Input 3
,
Input 4
,
Input 5
, or
Input 6
to select and display
the image for the source you connected in Step 2. The display will resize as needed
and produce largest possible image for the type of source present.
Optimize the Display
Press
Auto
Setup
on the built-in keypad (or
on the remote keypad) to initiate an
automated process in which the projector optimizes critical display parameters such as
size, position, pixel tracking, etc., for the current source.
Auto Setup
can save time in
perfecting a display and you can modify the adjustments later as desired. See
Section 3
.
STEP
4
Figure 2.1. Turning on the projector
STEP
5
STEP
6
