Installation & Setup
2-8
Roadster & Mirage S+/HD User Manual
020-100002-04 Rev. 1 (12-2008)
Extend the three stacking legs
Extend the stacking legs by turning them so
that at least one inch of thread is visible on
each. This clearance accommodates the up-
or-down movement for aligning the images
from the stacked projectors. Extend all three
legs equally (Figure 2.11).
•
If upright – extend legs on top projector
(shown).
•
If inverted – extend legs on bottom
projector.
IMPORTANT:
Extend the stacking legs
equally by at least 1 inch.
Loosen the rear stacking leg nuts
On the rear stacking legs, loosen the nuts so
the legs have some lateral movement for
easier alignment with the stacking mounts on the other projector.
Figure 2.12. Loosen 2 Nuts
•
If upright – release on top projector.
•
If inverted – release on bottom projector.
Figure 2.11. Extend 3 Stacking
Legs
(UPRIGHT STACK SHOWN)
STEP
3
STEP
4
