Christie Mirage S+14K, Replacement Instructions Manual

S

+

12K / 14K / 16K / 20K Lamp & Filter Instructions 

013-100049-03 (Rev.1)

6 of 8 Pages

Filter Replacement Procedure 

NOTE 

This procedure should be undertaken immediately  

after Step 8 of the 

Lamp Replacement Procedure

. 

The filter, located at the front side of the projector, should be changed whenever the lamp 
is replaced. If operating in an extremely dusty environment the filter may have to be 
replaced sooner. Use the filter provided in the Christie approved 

Lamp and Filter Kit

 for the 

specific projector model. For more information, refer to Table 1. Projector Models. 

STEP 1 — TURN OFF THE PROJECTOR, COOL and UNPLUG 

Before removing or installing a filter, turn off the projector and allow it to cool for five 
minutes before unplugging. 

STEP 2 - REMOVE FILTER DOOR 

NOTE 

When operating a Roadster S+20K 

also remove the triangular metal filter brace. 

Loosen the ¼-turn screw at the top of the filter grille/door. Lift the door away from the 
projector. Refer to Figure 7. 

Figure 7. Remove Filter Door 

OFFICIALLY RELEASED 

Document Control 

August 29, 2006