4. Level the wall mount and mark the center of the four mounting holes.
5. Drill four 5/32" (4 mm) diameter holes 2.5" (64 mm) deep.
6. Tighten the four #14 x 2.5" wood screws so that the wall plate is firmly attached, but do not
over-tighten.
Never tighten in excess of 80 in-lbs (9Nm).
Installing the mount to solid concrete or cinder block
Learn how to install the wall mounts onto solid concrete or cinder block walls.
Warning! Failure to comply with the following could result in death or serious injury.
•
Concrete must be a minimum of 2000 psi density. Lighter density concrete may not hold the
concrete anchor.
•
The supporting structure must safely support the combined load of the product, all attached
hardware, and components following all local safety standards and regulations.
When installing wall mounts onto cinder blocks, verify that you have a minimum of 1-3/8" (35 mm) of
actual concrete thickness in the hole to be used for the concrete anchors. Cinder block must meet
ASTM C-90 specifications and a minimum nominal width of 8".
1. Place the pull out mount assembly on the wall to use as a template, and verify the pull out
mount is level.
2. Mark the center of the four mounting holes.
3. Use a standard electric drill on slow setting to drill four 5/16” (8 mm) diameter holes to a
minimum depth of 2.5” (64 mm).
To avoid breaking out the back of the hole when entering a void or cavity, do not use a
hammer drill. On cinder block walls, mount in a solid part of the block, generally 1" (25 mm)
minimum from the side of the block. Do not drill into mortar joints.
4. Insert anchors into the holes flush with the wall.
Never attach concrete expansion anchors to concrete covered with plaster, drywall, or other
finishing material. If mounting to concrete surfaces covered with a finishing surface is
unavoidable, the finishing surface must be counter bored, as shown in the image below.
5. Place the pull out mount assembly over the anchors and secure it with four #14 x 2.5” screws.
Make sure concrete anchors do not pull away from the concrete when tightening screws. If the
wall is covered with plaster, drywall, or other finishing material thicker than 5/8" (16 mm),
custom fasteners must be supplied by the installer.
6. Tighten the four #14 x 2.5" wood screws so that the wall plate is firmly attached, but do not
over-tighten.
Never tighten in excess of 80 in-lbs (9Nm).
Installing flat panels on the ML20 wall mount
Installing Flat Panels on the ML20 Wall Mount Instruction Sheet
6
020-102525-01 Rev. 1 (02-2017)
Copyright
©
2017 Christie Digital Systems USA Inc. All rights reserved.
