Phoenix Quad-T Quick Start
Phoenix Quad-T Quick Start
2
020-000879-02 Rev. 1 (08-2017)
2.
Update the firmware.
Obtain the latest firmware file from the Christie web site.
Use the System Settings page in the Quad-T Web Manager to update the firmware.
3.
Configure the Encoder
sources using the Phoenix
Quad-T Web Manager.
Use the E1, E2, E3, and E4 pages in the Phoenix Quad-T Web Manager to configure the encoder
sources connected to Input 1-4. Each source is configured on the web page related to the physical
connector (for example, E1 is used to configure the source connected to HDMI 1).
•
Multicast addresses must conform to the following:
Must be validated for channels and across units
Must be approved for use on the network
Cannot conflict with other Quad-T units or other devices
•
Audio can be enabled
•
Bit rate can be adjusted to align with the bandwidth or quality
requirements.
4.
Add the Phoenix Quad-T
to your Phoenix system as
a RTSP source.
Log in to the Phoenix Web Manager and configure the Phoenix Quad-T as a RTSP source on your
Phoenix system.
Select QUADT as the Protocol Type.
Learn More
This is a Quick Start Guide. See the Phoenix Quad-T User Manual (020-101771-nn) for more details.
Christie Technical Support
For support, call 1-800-221-8025 (option 3) or email:
