16
Step 2:
Attach the pedal tube (6) and the swing tubes (4).
1. Remove the screws (57), wave washer (10), spring washers (52) and
D-shape washers (56) from long axle (12) and push the long axle (12)
centered into the holder of main frame (1). Put on one side the wave
washer (10) onto one axle (12).
2. Place the swing tube right (4R) on the right hand side of the main frame
(1) onto the end of long axle (12). (
Note: Right is specified as viewed
standing on the machine during training.) Put the D-shape washer (56) in
position and secure swing tube right (4R) by using screw (57) and spring
washer (52).
3. Screw the right pedal tube (6R) at the pedal crank (10) with axle screw
right (41R) tightly and secure position with spring washer (51) and right
nut (48R) firmly. Then put the screw caps (59+60) onto the front and rear
connection pointsof pedal tube right (6R).
(
Note: The screws (41L+R) are marked with “L” for left and “R” for right.
Please use appropriate nut for left and right screw. On right side the axle
screw and nut have to screw clock wise.)
4. Install the left pedal tube (6L) and swing tube (4L) incl. all additionally
required parts on the left hand side of the machine as described in 2. – 3.
(Note: The screw direction on left side for axle screw and nut is anti-clock
wise.)
Assembly Instructions
Remove all the separate parts from the packaging, lay them on the
floor and check roughly that all are there on the base of the assembly
steps. Please note that a number of parts have been connected directly
to the main frame and preassembled. In addition, there are several other
individual parts that have been attached to separate units. This will make
it easier and quicker for you to assemble the equipment.
Assembly time: 30 - 40 min.
Step 1:
Attach the stabilizer (2+3) at main frame (1).
1. Attach the front foot (2) with the preassembled transport rollers to the
main frame (1). Do this with the two screws M8x50 (37) curved washers
8//20 (46) and cap nuts (47).
2. Attach the rear foot (3) to the main frame (1). Do this with the two screws
M8x50 (37), curved washers 8//20 (46) and cap nuts (47).
Summary of Contents for 1320
Page 3: ...3 ...
