19
English
Step 4:
Installation of the pedal tubes (28) at swing tubes (38) and hand grips (41)
and connection at pedal cranks (12).
1. Push the end of the right pedal tube (28R) onto the right pedal crank
(12R) and tighten it with screw (24), washer (23) and spring washer (14)
firmly.
2. Push one save cover (40) onto the right swing tubes (38R). Push the
swing tube (38R) into the right handgrip (41R) and tighten it with screws
(13), spring washers (14) and washers (39) firmly.
3. Install the left pedal tube (28L) with all additionally required parts on the
left hand side of the machine as described in 1. - 2.
Step 5:
Installation of the front/rear pedal tube covers (25+35) and pedals (31)
on pedal tubes (28).
1. Push the rear pedal tube covers (25) onto the rear end of pedal tubes
(28) and fasten it with screws (26).
2. Put each one of left and right pedal front cover (35L+35R) onto the front
end of pedal tubes (28) together and fasten them with screws (11+26).
3. Place the footrest (31) onto the pedal tubes (28) so that the bores of
pedals (31) are aligned with one of the possible installation positions at
pedal tubes (28). (Note. The high edge on the long side of the footrest
must point inwards (towards the main frame (1).)
4. Put one oval washer (30) on each carriage bolt (29) and push through
the bores from the top and fasten from the bottom with washers (32),
the spring washers (33) and the hand grip nut (34).
(Note. The position adjusted in this way should always be equal at both
sides. The positions can be change as desired at all times by removing
the carriage bolts (29) and sliding the footrests on the footrest brackets.)
Step 3:
Installation of the right and left handgrip (41) on the handlebar post (19)
with the grip axle (44).
1. Put one spring washer (14) and one washer (23) on screw (24) and screw
tightly on one end of the grip axle (44).
2. Push the wave washer (37) onto the grip axle (44) and then push the grip
axle (44) step by step through the right hand grip (41R), handlebar post
(19) and left hand grip.
(Note. The handgrips are heavier at the top than at the bottom. Twist the
handgrips downwards until further installation is conducted.)
3. Push one spring washer (14) and one washer (23) onto the second screw
(24) and tighten the screw (24) at grip axle (44) firmly.
