18
Step 3:
Assembling of the connection cable (34) to the motor cable (35)
and installation of support (30) at the main frame (40).
1.
Place screws M8x20 (33), curved washers (31) and spring
washers (32) accessibly beside the front part of the main frame
(40).
2.
Place the lower end of the support (30) against the main frame
(40) and push the rubber ring (100) and support cover (101) onto
the support (30).
3.
Plug the ends of the two computer cable harnesses (34+35)
projecting from (30+40) together. (Note: The computer cable
harness (34) projecting from the support (30) must not slide into
the tube, as it is required for later steps of installation.)
When joining the tubes, ensure that the cable connection will
not trapped.
4.
Put one spring washer (32) and one curved washer (31) on each
screw (33). Push the screws (33) through the holes in the support
(30), screw into the threaded holes of the main frame (40) and
tighten lightly.
5.
Push the plastic cover (101) and rubber ring (100) into the right
position to cover the connection point.
Step 4:
Installation of handgrips (5), footrest holder (44) and connecting
tubes (25).
1.
Push the handgrip bars (5R) onto the connecting tubes (25R)
and adjust the holes in the tubes so that they are aligned.
(Note:
the handgrip bars must be aligned after assembly so that
the upper ends are inclined outwards (away from the support
(30)).
2.
Push the screws (33) through the holes and tighten the handgrip
bars (5) with curved washers (31) and spring washer (32) firmly.
3.
Put the footrest holder (44R) at the connecting tube (25R) and
adjust the holes in the tubes so that they are aligned.
4.
Push the screw M8x78 (23) through the holes and tighten the
footrest holder (44R) at connection tube (25R) with washers (27)
and nut (26) firmly. (This connection point has to move easily.
So please don’t tighten the screw too much.)
5.
Place the preassembled unit of the right footrest holder (44R)
and connecting tube (25R) at the right hand side of the main
frame (40).
(Note:
Right is specified as viewed standing on the
machine during training.)
6.
Push the grip axle (19) into the middle position at handlebar
support (30) and put one wave washer (20) and the connecting
tube (25R) onto the axles’ end (19). Put on the hex screw M8x20
(12) a spring washer (32) and a washer 8//32 (22) and tighten it
firmly.
7.
Put the foot pedal holder (44R) at the
pedal crank (97) and tighten them
with steel tube (52), washer 8//20 (49),
spring washer (32) and screw M8x20
(48) firmly.
8.
Install the left footrest holder (44L)
incl. all additionally required parts on
the left hand side of the machine as
described in 1. – 7.
9.
Put the plugs of pulse cables (10)
into the plugs from pulse connection
cables (16) and attach the screw caps
(11) onto screws (12).
Summary of Contents for 1908
Page 71: ...71 Русский ...
