19
English
Assembly Instructions
Remove all the separate parts from the packaging, lay them on the floor
and check roughly that all are there on the base of the assembly steps.
Please note that a number of parts are connected directly to the main
frame preassembled. In addition, there are several other individual parts
that have been attached to separate units. This will makes assembly
easier and quicker for you. Assembly time: 40 - 50 min.
Step 1:
Attach the stabilizer (59+86) at main frame (57).
1. Attach the front foot (86) with preassembled transportation roller (85) to
the main frame (57). Do this with screws M8x25 (99), washers (87) and
spring washers (14).
2. Attach the rear foot (59) with preassembled height adjustable caps (58)
to the main frame (57). Do this with screws M8x25 (99), washers (87)
and spring washers (14). After assembly has been complete, you can
compensate for minor irregularities in the floor by turning the wheel at
foot caps (58). The equipment should be set up that the equipment does
not move of its own accord during a training session.
3. Insert the rear plastic cover (45) into corresponding position on the side
covers.
Step 2:
Connection of cables (78+96) and assembly of support (92) at the main
frame (57).
1. Place screws M8x20 (56), curved washers (91) and spring washers (14)
accessibly beside the front part of the main frame (57).
2. Place the lower end of the support (92) against the main frame (57) and
push the support cover (89) with rubber ring (90) onto the support (92).
Plug the ends of the two computer cable harnesses (78+96) projecting
from (57+92) together.
(Note: The computer cable harness (19) projecting from the support (92)
must not slide into the tube, as it is required for later steps of installa-
tion.) When joining the tubes, ensure that the cable connection will not
trapped.
3. Connect the middle section tension cable (19) to the bracket of lower
section cable tension (96) (See figure [1]-[4]). Before this step of the
installation, it is advisable to adjust the resistance setting to the high-
est stage, at which the cable extends furthest from the sheath. Put the
lowest part of cable (19) into the small hook (figure 1+2). Pull it (figure
3) until the small hook get in higher position and then insert the cable
(19) onto the bracket (96) (figure 4).
4. Put one spring washer (14) and one curved washer (91) on each screw
(56). Push the screws (56) through the holes in the support (92), screw
into the threaded holes of the main frame (57) and tighten lightly. (This
screw connection point will screw firmly at least in Step 4.)
Summary of Contents for AL 3
Page 63: ...63 ...
