Programmable DC Power Supply (with Solar Array Simulation) 62000H Series
Operating & Programming Manual
4-14
4.1.2.3
Setting Time
1.
Use “
”, “
” keys to move the cursor to the column to be set as Figure 4-8
(3) shows.
2.
Use numeric keys
0
~
9
or “Rotary” (
) to set the value.
This function is to set the time sustained. This setting TIME = only appears when SEQ.
TYPE = AUTO.
3.
Press “
ENTER
” to confirm.
4.
Press “
EXIT
” to return to Program PAGE (Figure 4-3).
4.1.2.4
Setting Voltage
1.
Use “
”, “
” keys to move the cursor to the column to be set as Figure 4-8
(4) shows.
2.
Use numeric keys
0
~
9
or “Rotary” (
) knob to set the SEQ output voltage
3.
Press “
ENTER
” to confirm.
4.
Press “
EXIT
” to return to Program PAGE (Figure 4-3).
See section 3.2 for detail description.
4.1.2.5
Setting Voltage Slew Rate
1.
Use “
”, “
” keys to move the cursor to the column to be set as Figure 4-8
(5) shows.
2.
Use numeric keys
0
~
9
or “Rotary” (
) knob to set the SEQ voltage
conversion slew rate.
3.
Press “
ENTER
” to confirm.
4.
Press “
EXIT
” to return to Program PAGE (Figure 4-3).
See section 3.3.2.3 for detail description.
4.1.2.6
Setting Current
1.
Use
“
”, “
” keys to move the cursor to the column to be set as Figure 4-8
(6) shows.
2.
Use numeric keys
0
~
9
or “Rotary” (
) knob to set the SEQ output current
limit.
3.
Press “
ENTER
” to confirm.
4.
Press “
EXIT
” to return to Program PAGE (Figure 4-3).
See section 3.2 for detail description.
