Programmable DC Power Supply (with Solar Array Simulation) 62000H Series
Operating & Programming Manual
4-20
S T E P S T A T U S = A U T O E L A P S E
T I M E = 0 : 0 : 5 0
S T A R T _ V O L T
= 1 0 . 0 0 E N D _ V O L T
= 2 0 . 0 0
0 . 0 0 0 0 V 0 . 0 0 0 0 A
0 . 0 W
Figure 4-23
4.2.2.2
Description of Program V_Step Mode
When executing V_STEP MODE its main screen is as Figure 4-24 shows. The following
explains the meaning of (1)~(4) in Figure 4-24.
S T E P S T A T U S = A U T O E L A P S E
T I M E = 0 : 0 : 5 0
S T A R T _ V O L T
= 1 0 . 0 0 E N D _ V O L T
= 2 0 . 0 0
0 . 0 0 0 0 V 0 . 0 0 0 0 A
0 . 0 W
(3) (4)
(1) (2)
Figure 4-24
(1) START_VOLT: It is the start voltage setting of V_STEP MODE.
(2) END_VOLT: It is the end voltage setting of V_STEP MODE.
(3) STEP STATUS: It is the executing status of V_STEP MODE.
(4) ELAPSE TIME: It is the executed time of V_STEP MODE. The time format is
HOUR:MIN:SEC and the maximum display is 99 hours 59 minutes and 59 seconds.
4.3
IV PROGRAM
One can edit the IV Curve in IV PROGRAM. An IV-Program can add the IV-Sequence
freely to a maximum 100 IV Curves. The IV-Sequence setting is described in 4.3.2. Figure
4-25 shows the complete IV-Program structure.
