Power Supply Operation
3-15
The buttons used are the same as the ones for setting the units in series. This setup requires
only 1 unit. Before setting this unit to Master, disable the output.
1. Press the
Menu
button.
2. Rotate the Knob to show MA/SL on the display.
3. Press the
Menu
button to confirm.
4. Rotate the Knob to show SETUP on the display.
5. Press the
Menu
button to confirm.
6. Rotate the Knob to show MODE on the display.
7. Press the
Menu
button to confirm.
8. Rotate the Knob to show P-MA on the display.
9. Press the
Menu
button to finish the settings.
To quit the configuration, press any other key to exit.
●
Slave Unit (Quantity X 1 to 6)
:
The buttons used are the same as the ones used for setting the units in series. This
connection requires at least 1 unit and at most 6 units. For example: If two slave units are
required, each unit has to be set to the slave state. Before setting this unit to Slave, you have
to disable the output.
1. Press the
Menu
button.
2. Rotate the Knob to show MA/SL on the display.
3. Press the
Menu
button to confirm.
4. Rotate the Knob to show SETUP on the display.
5. Press the
Menu
button to confirm.
6. Rotate the Knob to show MODE on the display.
7. Press the
Menu
button to confirm.
8. Rotate the Knob to show P-SL on the display.
9. Press the
Menu
button to finish the settings.
To quit the configuration, press any other key to exit.
●
STATE ON
:
Before enabling the state, you have to disable the output. To activate the Master-Slave
function using parallel connections, you have to enable the state from OFF to ON through the
following procedures. When the slave state is enabled, the Slave signal will be shown at the
bottom right like the picture “Slave State.” However, when the master state is enabled, there is
no signal shown at the bottom right.
1. Press the
Menu
button.
2. Rotate the Knob to show MA/SL on the display.
3. Press the
Menu
button to confirm.
4. Rotate the Knob to show STATE on the display.
5. Press the
Menu
button to confirm.
6. Rotate the Knob to show ON on the display.
7. Press the
Menu
button to finish the settings.
To quit the configuration, press any other key to exit.
When the above settings are completed, but before enabling the output on the master unit,
the display on the master unit will show P-MA OFF, with P-SL OFF on the slave unit, as
shown in the picture to the right.
