Programmable DC Electronic Load 63600 Series Operation & Programming Manual
5-2
the electronic load to clear the activity that may
prevent it from receiving and executing a new
command. DCL and SDC do not change any
programmed settings.
5.1.3 USB in Remote Control
Supported Hardware:
USB 2.0 and USB 1.1
Supported Software:
USBTMC class and USB488 subclass
Installing Driver Program:
The USB Interface of 63600 Series supports USBTMC class; therefore, if the PC’s OS
supports USBTMC (the PC has installed NI-VISA runtime 3.00 or above) there is no need to
install other drivers in particular. The OS will search the standard USBTMC for installation
automatically.
If the PC’s OS does not support USBTMC, it is suggested to install NI-VISA runtime 3.00 or
above first. The USBTMC driver will be in the OS once the NI-VISA runtime is installed.
Power on the DC Electronic Load after connected it with the PC via USB cable and the user
can use the 63600 Series SCPI commands through
NI-VISA
to communicate with the DC
Electronic Load.
5.1.4 Ethernet in Remote Control
Before programming the electronic load remotely via an Ethernet computer, you need to
know the IP address, Gateway address and Subnet mask. Each device connected to the
Ethernet interface has a unique IP address assigned to it. Such address allows the system
controller to communicate with individual devices. To set the IP address of an individual
mainframe, Chroma 63600 series, it is done by
the “REMOTE” setting in the “CONFIG”
functional list menu only at each Modules
.
This section describes how to use Chroma DC Load 63600 network card rapidly and
correctly. Please read it carefully before using the 63600 network interface and ensure the
network is active and connected to hardware securely before execution.
The setting process is divided into four sections for as described below:
Summary of Contents for 63600 Series
