Space Force
TM
Protective Lens Kit QSG V2.0
QSG P/N: 650-0910
ii. For Space Force onebytwo
TM
and twobyfour
TM
: Remove the M3x10 Ultra Low
Torx Screws from Space Force
TM
unit using Torx T6 x 70mm screw driver. Keep
them in a secure location. These screws will be used to install the new
protective lens.
3. If a Protective Lens was already installed, remove the old Protective Lens. Keep
the Space Force
TM
Diffuser Lens as it is; align the new Protective Lens to match
the retaining screw holes.
4. Install the M3x10 ULTRA LOW HH ZN screws using Torx T6 x 70mm screw
driver.
Note
:
DO NOT tighten the screws with high torque. This might damage the Protective
Lens and/or the threads of the stand-off.
5. Further Information
Please refer to the Chroma-Q
®
Space Force
TM
manual for more detailed information. A
copy of the manual can be found at the Chroma-Q
®
website
Diffuser
Space Force
Chassis
Protective
Lens
M3 Ultra
Low Screw
