Page 13
Chunc Junior and Junior 45° setup
Safety note: A qualified health care professional should be present when fitting the Chunc
wheelchair and accessories to an occupant.
i
To make adjustments to the wheelchair’s setup, you may need to loosen a number of
indicated bolts, perform the adjustment and then re-tighten the bolts. An Allen key set is
located on the backrest to aid this.
Back recline
•
: Loosen 3 bolts (A) on both sides of the chair and reposition bolt (B) within
the indexing plate to determine the new recline angle. Re-tightened bolts (A).
Back height
•
: Adjust using 4 bolts (C).
Lumbar support
•
: A lumbar support can be located between the back pan and back foam.
This can be adjusted in height by removing the back cover and foam and positioning
where necessary.
Seat growth
•
: Remove seat cushion and lift the seat pan from 4 orange seat pan brackets.
Reposition 4 pan brackets using bolts (D).
Junior 45° only
: For additional seat growth, remove 4 bolts (E) to allow side plate move-
ment back and forth.
Junior and Junior 45°
: Snap seat pan back into place.
Chunc Junior and Junior 45° setup continued overleaf...
