Page 19
Chunc Adapt setup
Safety note: A qualified health care professional should be present when fitting the Chunc
wheelchair and accessories to an occupant. Ensure the wheelbase / surrogate seating combina-
tion has been passed by a qualified health care professional for stability before use. Please pay
attention to the safety label situated on the rail.
i
To make adjustments to the wheelchair’s setup, you may need to loosen a number of
indicated bolts, perform the adjustment and then re-tighten the bolts. An Allen key set is
located on the backrest to aid this.
Back recline
•
: Refer to Chunc Junior and Junior 45° setup.
Rail width adjustment
•
: Both 15” and 18” rail width models are available. To adjust, remove
the 4 bolts (A), add or remove spacers (B) and re-secure with the appropriate length bolts
from the kit provided.
Safety note: You should not perform this adjustment on an occupied wheelchair.
Rail length adjustment
•
: Loosen the 4 bolts (A). Use the 4 bolts (C) to adjust the position of
both side plates. Ensure bolts (A) are re-tightened thereafter. The back recline should also
be re-adjusted to support the back of a surrogate seating system.
Safety note: You should not perform this adjustment on an occupied wheelchair.
Harness mounting points
•
: Refer to Chunc Junior and Junior 45° setup.
Additional lower harness mounting
•
: Extra mounting is offered on the drop hook rails
(
).
