Page 25
Accessory setup and use (continued)
Please refer to the product specification matrix at the back of this manual for accessory / model
availability.
Safety note: A qualified health care professional should be present when fitting the Chunc
wheelchair and accessories to an occupant.
i
To make adjustments to the accessory’s setup, you may need to loosen a number of
indicated bolts, perform the adjustment and then re-tighten the bolts. An Allen key set is
located on the wheelchair backrest to aid this.
Knee blocks
•
:
Adjust general position using bolt (N) and reach individually using bolts (O). For angle
•
adjustment, remove bolts (P), relocate pad cups to the appropriate holes and move the
cup assembly to new sideways position.
Removal and fitment: To remove, pull the lever located on the underside of the as-
•
sembly and withdraw the assembly from the wheelchair. To refit, align the 2 bars with
the knee block mount holes and push the bars in until they reach a stop. Push the lever
downwards until it clicks to secure firmly in place.
Height-adjustable armrests
•
:
To adjust height, use the bolt (R).
•
The armrests may be removed using the orange collet.
•
Swing-away foot rests
•
:
Refer to “Chunc Junior and Junior 45° setup” and “Everyday use” section.
•
Spica wing support
•
:
Adjust height using bolt (S). For lateral position and angle adjustment, remove cover
•
and pad and use both bolts (T).
Harnesses
•
:
Refer to specific product setup sections and manufacture’s instructions.
•
