9
4. Operation (LCD model)
4.2.4 LCD indication of UPS alarm status and faults
In the event of an UPS fault, UPS enters fault operation mode, at this point, the fault icon turns on consist
-
ently, the buzzer beeps continuously and the data information area shows current fault code (refer to table
7-2), the display on the front panel is shown as the figure 5-5, users can switch to output page by pressing
function button.
When a warning occurred, the fault icon blinks every second, and users can switch to the alarm display page
shown as the figure 5-6 to check the warning code.
4.3 Operating Instructions
4.3.1 UPS ON/OFF Operation
Note: The battery is fully charged before delivery. However, storage and transportation will inevitably cause
some charge loss. Therefore, it is advisable to charge the battery for 10 hours before using it, so as to ensure
adequate battery capacity.
Figure 5-6 Alam display
A02
Figure 5-5 Fault display
F0 1
Summary of Contents for Venus Smart 1K
Page 20: ......
