4
GATE FITTING
The gate fitting must be installed so that it is horizontal relative to the post bracket. The distance between the gate bracket and post bracket is
referred to as the "arm span". When the gate is closed, the drive mechanism is 95% extended. When the gate is opened, the drive mechanism is
5% extended. Fully retracting or extending the plunger/spindle in operation (with gate) damages the drive mechanism and voids the warranty. It is
absolutely imperative to comply with the required arm span under all circumstances!
For steel gates, fixings should be welded on or through bolted. When through bolting the gate, use large washers or a plate on the other side.
The drive mechanism exerts an extremely high force on this joint.Fixings must be through bolted for wooden gates. It is recommended that metal
plates be fitted on either side of the gate, to prevent the fixings from becoming loose.
RELEASE
The drive mechanism can be released. The gate can then be opened
and operated manually (power failure). With a new drive mechanism,
the release action may sometimes feel stiff/jerky. This is normal and
has no effect on function.
Release and Engage
Place the hexagonal key into the hole provided in the cover. Engage
or disengage the motor.
