17
CO
ADIS LINE 900
HEAT PUMPS - AIR CONDITIONING - REFRIGERATION - AIR HANDLING - HEAT EXCHANGE - NA 14.712 A
Comfort units
Coanda effect cassette
The fan motor assembly,
mounted on anti-vibration mounts,
will be fitted with a low-consumption HEE motor with BLAC
(BrushLess Alternate Current) technology, which offers more
linear torque progression and a lower operating sound level
than BLDC (Brushless Direct Current) technology. All BLDC
motors will be prohibited. Single-phase 230V 50/60Hz, it may
be controlled by a progressive control signal 0-10V or 3-speed
ON/OFF with no need for an additional electronic board.
It will be fitted with an automatic overload protection with alarm
report via KNX bus. The centrifugal impeller with airfoil blades
will be balanced to prevent noise from vibrations. The system
mounting it on the drive shaft will be fitted with a foolproofing
device which prevents installation if incorrectly positioned, in
order to simplify maintenance. The fan motor assembly will be
removable from underneath.
An electrics box
that is enclosed and of large dimensions,
fitted with a DIN rail, will be able to accommodate and
protect all the control components from dust. The safety of
the electrical cables must be ensured using cable glands.
The electrical and hydraulic feeds must both be on the same
side to facilitate maintenance operations. In order to ensure
reliability, the control will be factory-fitted (except for the room
terminal) to eliminate any risks of leaks, for electrical safety
and for the proper protection of components.
The fresh air
enters through a smooth metal sleeve (with
no flow control) or via a self-adjusting collar and module
assembly designed to supply the determined flow rate with a
ΔP between 50 and 100 Pa.
Resilient mounts
will be placed between the unit's mountings
and the threaded rods to prevent any transmission of noise.
Guarantees
The manufacturer guarantees the equipment's performance,
and will provide the documents attesting to the equipment's
compliance with the attached specifications and with the
STANDARDS, in particular the heating and cooling capacity
(total and sensible), the air flow, the motor power input, the
efficiency of the filters and the sound power spectrum. Using
a simulation tool, the manufacturer of the terminal units must
be able to give the relevant comfort indices or the values
in compliance with the standard EN ISO 7730. The system
start-up and maintenance guide for the unit must be in the
language used in the country of installation. The manufacturer's
technical specifications and the equipment's sound pressure
must be given in the documents to be appended to the
submission.
This document is non-contractual. As part of its policy of continual product improvement, CIAT reserves the right to make any technical modification it feels appropriate without prior notification.
Head office
700 Avenue Jean Falconnier - B.P. 14
01350 - Culoz - France
Tel.: +33 (0)4 79 42 42 42
Fax: +33 (0)4 79 42 42 10
info@ciat.fr - www.ciat.com
Compagnie Industrielle d’Applications Thermiques - S.A. with a registered capital of 26 728 480 € - R.C.S. Bourg-en-Bresse B 545 620 114
Certified
Management System
