EN - 2
Main components
1- Recovery box. All new air in motorized mix
(accessory)
2- Electrical box
3- Name plate
4- Exchange coil
5- Insulated condensate drain pan
6- Plenum (accessory)
7- Removable lower panel (access to filter and
fan motor assembly)
Unit reception
The unit is supplied in labelled (fig. 2) with all the unit’s characteristics (type, model, item code, acknowledgement of receipt
number and customer details, etc.) enabling you to identify it precisely.
Each unit has an identification plate marked with an identification number to be given in all correspondence.
When the packages are received, the inspection of the condition of the goods at arrival is the recipient’s entire responsibility :
For shortages, the customer must mention the exact number of packages received.
In the event of defects on the units, the customer must describe the damage observed on the receipt in the presence of the
delivery person, and only sign the receipt after having done this.
IMPORTANT :
These remarks, in compliance with article 105 of the French trade code, must be confirmed by registered letter
to the transport operator within 3 working days. The terms ”reservations” and ”subject to unpacking” are not valid. The customer
must unpack the goods in the presence of the delivery person. Specific reservations at delivery are required.
Handling
Caution :
The unit must be handled with care. Shocks may buckle frame and damage the fanmotor assembly (ies). Preferably
the unit should be lifted by the mounting holes.
In the case where this method is not practical, it is possible to locate the unit with a fork lift, taking care not to damage the lower
panel.
Putting the unit in place
The unit should be fixed to the ceiling using threaded rods (not supplied). It should be perfectly level.
Make sure that the rear of the unit, in case of a non-ducted air intake, is far enough from the wall (min. 250 mm).
Fixation principle
Fig. 1
Fig. 3
Fig. 2
copie_de_NA0033B UTA STANDARD.qxd 31/05/2010 15:07 Page 2
