CI-202 Instruction Manual rev. 6/21/2017
1554 NE 3
rd
Ave, Camas, WA 98607, USA
Phone (360) 833-8835 Fax (360) 833-1914
16
4) Use the
UP or DOWN arrow to get to “Measure Root.” Press SAVE. The screen will
flash “measure root saved.” Then the screen will show “Set-up Measure.”
5)
Use the RIGHT arrow key to scroll to “Set-up Scanner.” Press ENTER. You will see
“HiThld Scan.”
6) Use the UP or
DOWN arrows to scroll to “filter scan.” Press ENTER. You will see
“Filter on On or Off”
7)
Use the UP or DOWN arrow key to get to “Filter off.” Press STOP TWICE and then
SAVE.
The screen will flash “Root params saved” indicating that the root parameters
have been saved. This will turn the filter off and save the changes.
8)
The screen will come up “Set-up Scanner.” Press ENTER.
9)
Use the UP or DOWN arrow key to get to “Manual Scan.” Press ENTER.
10) You will hear the motor start and the laser line will come on.
11) W
ith the laser line over the reflective material only watch the “w” value. It should read
the value as w = 1.
12)
When you MOVE the laser scanner over the inspection standard, the “w” value should
read 2. Press STOP. The inspection standard is a piece of white paper with known
length and width.
13)
Use the UP or DOWN arrow to scroll to “Filter Scan.” Press ENTER.
14) The value in the bottom center of the screen should read 1.
15) Using the UP or DOWN arrow, turn the filter on and press STOP TWICE and SAVE
(the screen will flash “Root params saved”). This will turn the filter on and save the
setting.
The screen will come up “Set-up scanner.” Press ENTER
16) Use the UP or DOWN arrows to
get to “HiThld Scan.” Press ENTER.
17)
You will see the “t” value and “w” value change. Watch the t value closely. The “t”
value will go down, then stop and set itself. Note the number it stops and sets at and
write down the number setting. It should settle b
elow 50, with somewhere in the 20’s
being desirable.
18)
Use the UP or DOWN arrow keys to get to the “LoThld Scan.” Place a piece of white
paper under the scan area on the right edge.
19) Press ENTER.
20)
Again the “t” value will go down. The low threshold will also stop and set itself like the
high threshold did in step 17. Write down and note the number setting.
21) Add the HiThld setting number and the LoThld setting number and divide by 2. This
will give you your average setting number. Write down and note the number. Remove
the white paper from under the scanner.
22)
When you have this information use the UP or DOWN arrow keys to scroll to “Manual
Scan.” Press ENTER.
