CIGWELD Transmig 165ST Service Manual Download

Page: 7 / 126

SERVICE MANUAL

Transmig 165

SERVICE MANUAL

Transmig 165

Manual 0-5442 1-1

GENERAL INFORMATION

1.01 Arc Welding Hazards

WARNING

ELECTRIC SHOCK can kill.

Touching live electrical parts can cause fatal

shocks or severe burns. The electrode and

work circuit is electrically live whenever

the output is on. The input power circuit

and machine internal circuits are also live

when power is on. In semiautomatic or

automatic wire welding, the wire, wire

reel, drive roll housing, and all metal parts

touching the welding wire are electrically

live. Incorrectly installed or improperly

grounded equipment is a hazard.

1. Do not touch live electrical parts.
2. Wear dry, hole-free insulating gloves and body

protection.

3. Insulate yourself from work and ground using dry

insulating mats or covers.

4. Disconnect input power or stop engine before

installing or servicing this equipment. Lock input

power disconnect switch open, or remove line

fuses so power cannot be turned on accidentally.

5. Properly install and ground this equipment

according to its Owner’s Manual and national,

state, and local codes.

6. Turn off all equipment when not in use. Disconnect

power to equipment if it will be left unattended or

out of service.

7. Use fully insulated electrode holders. Never dip

holder in water to cool it or lay it down on the

ground or the work surface. Do not touch holders

connected to two welding machines at the same

time or touch other people with the holder or

electrode.

8. Do not use worn, damaged, undersized, or poorly

spliced cables.

9. Do not wrap cables around your body.
10. Ground the workpiece to a good electrical (earth)

ground.

11. Do not touch electrode while in contact with the

work (ground) circuit.

12. Use only well-maintained equipment. Repair or

replace damaged parts at once.

13. In confined spaces or damp locations, do not use

a welder with AC output unless it is equipped with

a voltage reducer. Use equipment with DC output.

14. Wear a safety harness to prevent falling if working

above floor level.

15. Keep all panels and covers securely in place.

SECTION 1:

ARC WELDING SAFETY INSTRUCTIONS AND WARNINGS

WARNING

PROTECT YOURSELF AND OTHERS FROM POSSIBLE SERIOUS INJURY OR DEATH. KEEP CHILDREN

AWAY. PACEMAKER WEARERS KEEP AWAY UNTIL CONSULTING YOUR DOCTOR. DO NOT LOSE THESE

INSTRUCTIONS. READ OPERATING/INSTRUCTION MANUAL BEFORE INSTALLING, OPERATING OR

SERVICING THIS EQUIPMENT.

Welding products and welding processes can cause serious injury or death, or damage to other equipment or

property, if the operator does not strictly observe all safety rules and take precautionary actions.
Safe practices have developed from past experience in the use of welding and cutting. These practices must be

learned through study and training before using this equipment. Some of these practices apply to equipment

connected to power lines; other practices apply to engine driven equipment. Anyone not having extensive

training in welding and cutting practices should not attempt to weld.
Safe practices are outlined in the Australian Standard AS1674.2-2007 entitled: Safety in welding and allied

processes Part 2: Electrical. This publication and other guides to what you should learn before operating

this equipment are listed at the end of these safety precautions.

HAVE ALL INSTALLATION, OPERATION,

MAINTENANCE, AND REPAIR WORK PERFORMED ONLY BY QUALIFIED PEOPLE.