OPERATING MANUAL
OPERATION
4-12
Manual 0-5586
LIFT TIG Mode Advanced Features Menu Map
Advanced Menu -
LIFT TIG Mode
Press Advanced Button
to Exit to Welding Mode
Left Knob Selection
Right Knob Selection
DOW
Advanced Menu - LIFT
TIG Options or Range
Press Advanced Button
to Exit to Welding Mode
0-5 S
Art # A-14701
Left Knob
Right Knob
Press
Press
Figure 4-5: LIFT TIG Advanced Menu
Function
Left Display
"Right Display
(Factory Default
Values)"
Limits Comments
Down Slope
DOW
0.0 S
0 – 5 S
In “2T” (unlatched), the unit will enter down
slope mode as soon as the trigger switch is
released (ie if Down Slope is set to 5.0 S, the
unit will ramp down from the present welding
current to zero over 5 seconds).
In "4T" (latched), to enter down slope mode the
trigger switch must be held in for the selected
time period (ie press and release trigger switch
to commence welding, then press and hold
trigger switch again to enter down slope mode).
Should the trigger switch be released during
the down slope time, the output will cease
immediately in "4T" only.
NOTE!
The "
R/L
" settings will revert to the factory default setting each time the weld process is changed. A setting other than
the default will only be remembered while in that process.
Summary of Contents for Transmig 355i
