GB
GB
GB
GB
GB
12
12
12
12
12
Setting the hardness of b
Setting the hardness of b
Setting the hardness of b
Setting the hardness of b
Setting the hardness of blended w
lended w
lended w
lended w
lended water
ater
ater
ater
ater
Close the blending valve (V
V
V
V
V) clockwise and then in-
crease the blended water hardness by opening
gradually (increasing arrow).
To test the water hardness, allow the nearest cold
water tap to run for a while and check the hardness
of the blended water. Adjust with the blending valve
(V
V
V
V
V) until the desired value (recommendation 4° – 8
°dH) is reached.
Sodium content of par
Sodium content of par
Sodium content of par
Sodium content of par
Sodium content of partially softened w
tially softened w
tially softened w
tially softened w
tially softened water
ater
ater
ater
ater
The sodium content increases by 8.2mg/l if the hard-
ness of drinking water is decreased by 1°dH.
Hardness of drinking water – hardness of blended
water x 8.2mg/l = increase in the sodium content.
Chec
Chec
Chec
Chec
Check connections and pipeline junctions f
k connections and pipeline junctions f
k connections and pipeline junctions f
k connections and pipeline junctions f
k connections and pipeline junctions for leaks
or leaks
or leaks
or leaks
or leaks
once again.
once again.
once again.
once again.
once again.
The unit is now ready for use.
T
T
T
T
Trrrrransf
ansf
ansf
ansf
ansferr
err
err
err
erring the unit to the oper
ing the unit to the oper
ing the unit to the oper
ing the unit to the oper
ing the unit to the operator
ator
ator
ator
ator:::::
If there is a delay between the installation/start-up
of the unit and transfer to the operator, a manual
regeneration must be performed.
The operator must be told how the unit works as
well as how to operate and inspect it. Ensure that
the operator receives the installation and operating
manual.
V
V
V
V
V
