21
BLITZ
5-1996
UM55T03I
THE TRACTOR'S PTO SHOULD DELIVER A POWER HIGHER THAN THAT ABSORBED BY THE SPRAYER
UNDER ALL WORK CONDITIONS.
5.1.
1
Sprayer with standard drawbar
EXECUTION
1. The coupling should be done on a flat surface, taking care of clearing away all the people not involved in the operation,
including children and animals.
2. The tractor drawbar should be in central position.
3. Put the tractor near and in line with the sprayer.
4. .
Stop the tractor. Take the keys out of the control panel.
5. Adjust the rudder length. The drawpoint should be as far as possible equidistant from the 2 PTO's.
6. Choose the position of the trail eye: up or down. The sprayer should operate as horizontal as possible. If the ground
allows it, also adjust the axle height.
7. Fix the rudder to the frame.
8. Position the rudder trail eye at the same height as the trail fork, by adjusting the bearing foot.
9. Start the tractor and insert the trail eye in the fork, following the instructions of point 1.
10.
Stop the tractor. Take the keys out of the control panel.
11. Lock the hook by means of the safety release pin.
12. Completely lift the bearing foot.
13. Place the 2-cocks P8 manual distributor or the E8 electric control unit near the driver by inserting its supply plug
into the tractor socket.
14. Screw the two supply pipes to the distribution device (head).
5.1.
2
Sprayer with swivelling drawbar
EXECUTION
1. The hitching should be made on a flat surface, taking care of clrearing away all the people not involved in the operation,
including children and animals.
5 HITCHING MODE 5
5.1 - TRACTOR HOOK-UP
THE SPRAYER IS NOT APPROVED FOR DRIVING ON THE ROAD.
To be coupled with tractors of at least
BLITZ
45T
BLITZ
50T
BLITZ
55T
BLITZ
55TS
BLITZ
55TE
CV SAE
45
65
70
80
90
kW
33
48
52
59
66