39
Proceed as follows for replacement
1. Separate the connected measuring leads from the measuring circuit and the measuring device.
2. Switch the DMM off.
3. Unscrew the screws on the battery cover, carefully remove the battery cover and battery.
4. Unscrew the two screws on the back of the device and carefully pull the casing apart.
5. Replace the defective fuse with a new fuse of the same type and nominal voltage. The fuses have the
following values:
· F1 fine-wire fuse, quick-action, 0.2 A/600 V (6 x 32 mm).
· F2 fine-wire fuse, quick-action, 10 A/600 V (6 x 25 mm).
6. Now close the housing carefully again.
d) inserting/replacing the battery
Do not leave flat batteries in the device. even batteries protected
against leaking can corrode and thus release chemicals which may be
detrimental to your health or destroy the battery compartment.
Do not leave batteries lying around carelessly. they might be
swallowed by children or pets. if swallowed, consult a doctor
immediately.
if the device is not used for longer periods of time, remove the
batteries in order to prevent leaking.
leaking or damaged batteries might cause acid burns when getting
into contact with skin. therefore, use suitable protective gloves.
make sure that the batteries are not short-circuited. Do not throw
batteries into fire!
Batteries may not be recharged. Danger of explosion!
Operation of the measuring device requires a 9 V battery (e.g. 1604A). You need to insert a new,
charged battery prior to initial operation or when the battery change symbol
appears on the display.
To insert/replace the battery, proceed as follows:
1. Separate the connected measuring leads from the measuring circuit and the measuring device. Switch
the DMM off.
2. Unscrew the screw on the rear of the battery compartment (6) and carefully pull the battery cover
and the battery out of the measuring device.
3. Insert a new battery with the correct polarity into the battery cover, insert them into the DMM.
Summary of Contents for 11 1406
Page 87: ...87...
