6
OXE DIESEL SINGLE CONTROL HEAD MANUAL
SAFETY REGULATIONS
SAFETY REGULATIONS
!
WARNING
The safety information provided below is intended to inform you of the
dangers that may be present before, during and after use. It is critical that
you read and understand all the points noted.
!
WARNING
The OXE Diesel Control Head system must only be installed by an authorized
dealer or OEM.
Safe operation of the shift and throttle system depends upon proper installation
and maintenance of the system, and common sense, safe judgment, knowledge,
and expertise of the operator. Every installer and operator of the shift and throttle
system should know the following requirements before installing or operating the
system.
If you have any questions regarding any of these warnings, contact your
OXE
Diesel retailer
.
To reduce the risk of severe injury or death:
1.
Always wear a Coast Guard-approved personal flotation device (PFD) and
use an engine shut-off cord (lanyard).
2.
Read and understand this manual and the Quick Reference Card provided
with your boat control components.
3.
OXE Diesel
components are highly engineered and safety tested to ensure
system integrity. DO NOT substitute any component. Substitution with
non-OXE
components may compromise system safety, performance, and
reliability.
PRIOR TO EVERY USE
Perform a system inspection as outlined below. See section
Operation
for further
details.
1.
Check your boat’s steering system for proper operation.
2.
Inspect all electrical cables for wear, kinks, or leaks.
3.
Check for binding, loose or worn shift/throttle control components.
4.
Verify proper shift and throttle response for all control levers.
!
WARNING
Do not operate boat if any components is not in proper working condition.